Procedure In The Efi Shell - B&R Automation PC 2200 User Manual

Software
4. Under Filename enter the name of the firmware file or select a file.
5. Click Open. Dialog box "Open" opens.
The transfer can be canceled by clicking on Cancel in the download dialog box. Cancel is disabled while writing
to flash memory.
Erasing the data in flash memory can take several seconds depending on the memory module used. During this
time, the progress indicator is not updated.
Information:
The power supply to the PC or Automation Panel must be switched off and on again for the new
firmware to take effect and the updated version to be displayed. When exiting the Control Center, a
corresponding prompt for this is displayed.
Information:
For more detailed information about saving and updating the firmware, see the ADI driver user's man-
ual.

4.2.3.2 Procedure in the EFI shell

1. Download the ZIP file from the B&R website (www.br-automation.com).
2. Unzip the ZIP file and copy the files to a USB flash drive formatted in FAT16 or FAT32. Alternatively, a CFast
card can also be used.
3. Reboot the PC and select "Internal shell" as the boot device ("Esc", "Del" or "F2" key to open the boot menu).
4. After booting the EFI shell, "startup.nsh" is executed and the MTCX, SDLT and SDL4T upgrades are started
in sequence.
5. After a successful upgrade, a the system must be switched off and on again.
Information:
The power supply to the PC or Automation Panel must be switched off and on again for the new
firmware to take effect and the updated version to be displayed.
166 Automation PC 2200 User's manual V 1.05 Translation of the original documentation