Complete System; Connection Options; Sdl Operation - B&R Automation PC 2200 User Manual

2.2 Complete system

2.2.1 Connection options

An Automation Panel can be connected to the Automation PC with an optional monitor/panel option via DVI, SDL
or SDL4. The connection options described below provide an overview of the operating modes and possible lim-
itations.
Information:
In its minimum configuration, the APC2200 has no possibility to connect an external display (e.g. Au-
tomation Panel). In order to implement a display option, a monitor/panel option must be included in
the configuration. This option can only be added at the B&R factory and cannot be retrofitted.

2.2.1.1 SDL operation

2.2.1.1.1 SDL operation mode 1
In SDL operation mode 1, all communication between the Automation Panel and B&R industrial PC takes place
via a single SDL cable.
In addition to the display data, information from the touch screen, matrix keys, LEDs and service/diagnostic data is
transferred. The Automation Panel can be installed up to 40 m away from the B&R industrial PC. USB 1.1 is also
transferred over this distance and fully integrated into SDL. External adapter modules are not required.
The brightness of the display can be set via the B&R Control Center, for example.
Power supply
Grounding
Availability of the interfaces on the Automation Panel with SDL/DVI receiver:
✓
Panel In
✓
USB1, USB2 USB 1.1
Maximum cable length: 40 m
Requirements
• Automation Panel with SDL/DVI receiver
• B&R industrial PC with SDL interface
• SDL cable
Automation PC 2200 User's manual V 1.05 Translation of the original documentation
SDL operation mode 1
Automation Panel
with SDL/DVI receiver
USB In
COM interface for touch
screen
SDL cable
x Power supply
x Grounding
Technical data
Power supply
Grounding
B&R industrial PC
✓
Brightness controls
✓
x
17