Servicing/Maintenance; Replacing Cfast Cards - B&R Automation PC 2200 User Manual

7 Servicing/Maintenance

The following chapter describes the servicing and maintenance work that can be carried out by a qualified and
trained end user.
Information:
Only components approved by B&R are permitted to be used for servicing and maintenance work.

7.1 Replacing CFast cards

Caution!
The CFast card is only permitted to be replaced when the power is switched off.
Improper handling of the ejection lever (e.g. applying a large amount of force) can lead to a defect in
the ejector mechanism.
1. Disconnect the power supply cable to the B&R industrial PC (disconnect the power cable).
2. Remove the Torx screw (T10) of the cover plate.
3. Remove the cover plate.
4. Press the ejector next to the card slot (see figure below).
The card is ejected and can be replaced.
Automation PC 2200 User's manual V 1.05 Translation of the original documentation
Figure 87: Removing the cover of the CFast slots
Figure 88: Pressing the ejector and removing the CFast card
Servicing/Maintenance
217