Spacing For Air Circulation - B&R Automation PC 2200 User Manual

2.2.2.3 Spacing for air circulation

To ensure sufficient air circulation, a specified clearance must be provided above, below, to the side and rear of
the unit. For the minimum specified clearance, see the following diagrams. This is valid for all variants.
Information:
The following figure and table exclusively show the thermal view of the complete system. If additional
space is required for operating or servicing the device, this must be taken into account during instal-
lation.
S1
S4
S3
S1: ≥100 mm
S2: ≥50 mm
S3: ≥100 mm
S4: ≥50 mm
Caution!
The specified spacing for air circulation applies to worst case operation at the maximum specified
ambient temperature. The maximum specified ambient temperature is not permitted to be exceeded!
If the specified spacing for air circulation cannot be maintained, the maximum specified temperatures
of the temperature sensors (see
the user and appropriate measures taken if these values are exceeded.
Automation PC 2200 User's manual V 1.05 Translation of the original documentation
Air outlet
S2 S4
Air inlet
Figure 4: Automation PC 2200 - Spacing for air circulation
"Temperature sensor positions" on page
Technical data
S1
Air outlet
S3
Air inlet
29) must be monitored by
S2
23