Usb Interfaces - B&R Automation PC 2200 User Manual

2.2.6.5 USB interfaces

Automation PC devices are equipped with a USB 3.0 (Universal Serial Bus) host controller with several USB ports,
of which two USB 3.0 interfaces are routed externally and freely available to the user.
Warning!
USB peripheral devices can be connected to the USB interfaces. Due to the variety of USB devices
available on the market, B&R cannot guarantee their functionality. The functionality of USB devices
available from B&R is guaranteed.
Caution!
Due to the general PC specification, this interface must be handled with the utmost care with regard
to EMC, cable routing, etc.
USB1, USB2
Type
Variant
Transfer rate
Current-carrying capacity
3)
USB1
USB2
Cable length
USB 2.0
USB 3.0
1) The interfaces, etc. available on the device or module have been numbered for the purpose of clear differentiation. This numbering may deviate from the
numbering used by the respective operating system, however.
2) Compatibility with SuperSpeed depends on the operating system used.
3) The USB interface is protected by a maintenance-free "USB current-limiting switch" (max. 1 A).
Automation PC 2200 User's manual V 1.05 Translation of the original documentation
Universal Serial Bus (USB1, USB2)
USB 3.0
Type A
Low speed (1.5 Mbit/s), full speed (12 Mbit/s),
high speed (480 Mbit/s) to SuperSpeed (5 Gbit/s)
Max. 1 A
Max. 1 A
Max. 5 m (without hub)
Max. 3 m (without hub)
Table 26: USB1, USB2 interface
1)
2x USB type A, female
2)
1 2
USB 1 USB 2
Technical data
3
41