Power Supply Connectors; 0Tb103.9X; General Information; Order Data - B&R Automation PC 2200 User Manual

6.2 Power supply connectors

6.2.1 0TB103.9x

6.2.1.1 General information

1-row 3-pin terminal block 0TB103 is used for the power supply.

6.2.1.2 Order data

Model number Short description
Terminal blocks
0TB103.9 Connector 24 VDC - 3-pin female - Screw clamp terminal block
3.31 mm²
0TB103.91 Connector 24 VDC - 3-pin female - Cage clamp terminal block
3.31 mm²

6.2.1.3 Technical data

Information:
The following specified characteristic data, features and limit values are only valid for this accessory
and may differ from those of the complete system. The data specified for the complete system applies
to the complete system in which this accessory is installed, for example.
Model number
General information
Certifications
CE
UL
HazLoc
DNV GL
Terminal block
Note
Number of pins
Type of terminal block
Cable type
Spacing
Connection cross section
AWG wire
Wire end sleeves with plastic covering
Solid wires
Fine strand wires
With wire end sleeves
Tightening torque
Electrical characteristics
Nominal voltage
Nominal current
4)
Contact resistance
Operating conditions
Pollution degree per EN 61131-2
1) Yes, but applies only if all components installed in the complete system have this certification and the complete system bears the corresponding mark.
2) Yes, but applies only if all components installed in the complete system have this certification and are listed on the associated DNV GL certificate for the
product family.
3) The cage clamp terminal block cannot be used side by side.
4) The respective limit data of the I/O modules must be taken into account!
Automation PC 2200 User's manual V 1.05 Translation of the original documentation
Table 207: 0TB103.9, 0TB103.91 - Order data
0TB103.9
Screw clamp terminal block variant
26 to 14 AWG
0.20 to 1.50 mm²
0.4 Nm
Table 208: 0TB103.9, 0TB103.91 - Technical data
Yes
cULus E115267
Industrial control equipment
cULus HazLoc E180196
Industrial control equipment
for hazardous locations
Class I, Division 2, Groups ABCD, T4
Temperature: B (0 - 55 °C)
Humidity: B (up to 100%)
Vibration: A (0.7 g)
EMC: B (bridge and open deck)
Protected against vibration by the screw flange
Nominal data per UL
3 (female)
Cage clamp terminal block variant
Only copper wires (no aluminum wires!)
5.08 mm
0.20 to 1.50 mm²
0.20 to 2.50 mm²
0.20 to 1.50 mm²
300 V
10 A / contact
≤5 mΩ
Pollution degree 2
Accessories
Figure
0TB103.91
1)
2)
3)
26 to 12 AWG
0.20 to 2.50 mm²
-
183