Connecting The Power Supply To A B&R Device - B&R Automation PC 2200 User Manual

Commissioning
3.3 Connecting the power supply to a B&R device
Danger!
The entire power supply to the B&R device must be interrupted. Before connecting the power cable, it
must be checked whether it has been disconnected from the voltage source (e.g. power supply).
1. Carry out electrostatic discharge on the housing or at the ground connection.
2. Connect the power supply connector to the B&R device and tighten the mounting screws (max. tightening
torque 0.5 Nm).
128
Figure 36: Connecting the power supply connector to a B&R device
Automation PC 2200 User's manual V 1.05 Translation of the original documentation