Automatic Setup For Japanese Language - GE LOGIQ 7 Service Manual

GE H
EALTHCARE
D 2286865, R
IRECTION EVISION
8-2-10-7 Regional Setup (For the system with language other than English ONLY) (cont'd)
13.)Select Automatic Setup for Japanese Language button. Then IME configuration shall be
automatically done.
This configuration shall setup the keyboard assignment (remove 半角かな , etc) in IME.
14.)Reboot the system.
15.)To type Japanese, press Alt+
You can use the following short cut keys.
-
-
-
-
When pressing F6 Key, the following message is displayed at the status bar.
NOTICE
"Select the key which the macro is assigned to."
You can ignore this message.
Section 8-2 - Software Loading Procedures for BT09 (R8.x.x or later)
14
Figure 8-104 Automatic Setup for Japanese Language
F6 key: Hiragana
F7 key: Katakana
F9 key: alphameric two-byte character
F10 key: alphameric one-byte character
(right side of the Escape key) to start IME (Input Method Editor).
LOGIQ™ 7 S M
ERVICE ANUAL
8-43