Right Tamper Jam Service Check - Lexmark M52 Series Service Manual

Action
Step 16
Reinstall or replace the tamper aligner. See
removal" on page 627.
Does the problem remain?
Step 17
Check the tamper gear for improper installation and damage.
Is the gear properly installed and free of damage?
Step 18
Reinstall or replace the gear. See
page 620.
Does the problem remain?
Step 19
Make sure that the controller board of the affected optional bin is
properly installed. Reseat all the cables on the controller board.
Does the problem remain?
Step 20
Check the affected controller board and its connector pins for
damage.
Are the bin controller board and its connectors free of damage?
Step 21
Replace the bin controller board. See
board removal" on page
Does the problem remain?

Right tamper jam service check

Action
Step 1
Make sure that all the optional bins are properly installed.
Does the problem remain?
Step 2
Open all optional bin doors, and then check the paper path and
bins for paper fragments and partially fed paper.
Is the paper path free of paper fragments and partially fed paper?
"Tamper aligner
"Tamper drive belt removal" on
"Staple finisher controller
590.
Diagnostics and troubleshooting
Yes
Go to step 17.
Go to step 19.
Go to step 19.
Go to step 20.
Contact the next
level of support.
Contact the next
level of support.
Yes
Go to step 2.
Go to step 4.
239
4064
No
The problem is
solved.
Go to step 18.
The problem is
solved.
The problem is
solved.
Go to step 21.
The problem is
solved.
No
The problem is
solved.
Go to step 3.