Left Tamper Jam Service Check - Lexmark M52 Series Service Manual

Left tamper jam service check

Action
Step 1
Make sure that all the optional bins are properly installed.
Does the problem remain?
Step 2
Open all optional bin doors, and then check the paper path and
bins for paper fragments and partially fed paper.
Is the paper path free of paper fragments and partially fed paper?
Step 3
Remove the paper fragments and partially fed paper.
Does the problem remain?
Step 4
Clear the optional bin paper path rollers of any dirt and
contamination.
Does the problem remain?
Step 5
a
Enter the Diagnostics menu, and then navigate to:
Output bin quick feed > Feed to all bins
b
Touch Single or Continuous.
Does the problem remain?
Step 6
a
Enter the Diagnostics menu, and then navigate to:
Output device adjustments/tests > Output device sensor
tests > Stapler
b
Find the sensor (Tamper, left).
Does the sensor status change while toggling the sensor?
Step 7
a
Remove the staple finisher top cover. See
cover removal" on page
b
Remove the staple finisher left cover. See
cover removal" on page
c
Reseat the cable on the sensor (staple finisher left tamper) and
on the staple finisher controller board.
Does the problem remain?
"Staple finisher top
588.
"Staple finisher left
584.
Diagnostics and troubleshooting
237
Yes No
Go to step 2. The problem is
solved.
Go to step 4. Go to step 3.
Go to step 4. The problem is
solved.
Go to step 5. The problem is
solved.
Go to step 6. The problem is
solved.
Go to step 10. Go to step 7.
Go to step 8. The problem is
solved.
4064