Table of Contents
Advertisement
3.25. Software shutdown
The Advanced Power Controller can also be switched off by
a software command.
When the software shutdown function is activated:
•
The digital input is only enabled if it is associated with
the software shutdown function.
•
Outputs are forced to OFF at shutdown. The exception
is the reference signals rL.4 and rL.6, which are forced
to ON.
•
HB alarms are reset.
•
The generic alarms AL1...AL8 can be enabled or disa-
bled via the parameter oFF.t.
3.25.1.
Software startup/shutdown
Address
Format
Single-
Multi-
node
node
1035
2059
11
bit
4107
The bit sets the software startup and shutdown.
Options:
OFF
= Software on
ON
= Software off
3.25.2.
Software shutdown modes
Address
Format
Single-
Multi-
node
node
1724
700
16 bit
The parameter sets the software shutdown mode.
Options:
GPC-OP
Acronym
menu
12.01.02
M
BIT_
SOFT-
12.02.02
E1
WARE_
ON_OFF
12.03.02
E2
GPC-OP
Acronym
menu
OFF.t
Global MainMenu → Global → Controls → OFF.t R/W
Index
Outputs rL.1 - rL.2 - rL.3 - rL.5 = OFF
0
Outputs rL.4 - rL.6 = ON
Generic alarms AL1...AL8 disabled
Outputs rL.1 - rL.2 - rL.3 - rL.5 = OFF
1
Outputs rL.4 - rL.6 = ON
Generic alarms AL1...AL8 enabled
81901 "MSW_GPC-40/600A"_03-2021_ENG_page 104
In addition to the parameters shown below, the following
parameters should also be considered for software shut-
down:
•
digital input function dIG.1 / dIG.2 / dIG.3 / dIG.4 (see
paragraph "3.12.4. Digital input function");
•
status (STATUS_W) (see paragraph "3.22.3. Status
(STATUS_W)");
•
digital input status dIG.1 / dIG.2 / dIG.3 / dIG.4 (see
paragraph "3.12.2. Digital input status").
GF_eXpress menu
Description
MainMenu → M → Expert →
Bit → IT_SOFTWARE_ON_OFF_1
MainMenu → E1 → Expert →
Bit → IT_SOFTWARE_ON_OFF_2
MainMenu → E2 → Expert →
Bit → IT_SOFTWARE_ON_OFF_3
GF_eXpress menu
Description
Description
■
R/W
Unsigned
■
Short
OFF
0
Advertisement
Table of Contents
