Software Shutdown - gefran GFW 400-600A Configuration And Programming Manual

SOFTWARE SHUTDOWN

Running the software shutdown procedure causes the following:
1) Digital input enabled only if assigned to SW shutdown function.
2) Outputs OFF: except for signals them of reference rL.4 and rL.6 that they come forced ON
3) Reset of HB alarm.
4) Alarms AL 1... AL 4 can be enable or disable through the parameter oFF.t.
140 diG.1
618 diG.2
694
diG.3
712 diG.4
SOFTWARE
11
LAUNCH/
bit
SHUTDOWN
700
0FF.T
Read state
68
STATE of DIGI-
bit TAL INPUT 1
92
STATE of DIGI-
bit TAL INPUT 2
67
STATE of DIGI-
bit TAL INPUT 3
66
STATE of DIGI-
bit TAL INPUT 4
305*
80997D_MSW_GFW_400-600_04-2021_ENG
R/W
Digital input function 1
R/W
Digital input function 2
R/W
Digital input function 3
R/W
Digital input function 4
OFF = On software
R/W
ON =Off software
Modes at software
R/W
shutdown
OFF = Digital input 1 off
R
ON = Digital input 1 on
OFF = Digital input 2 off
R
ON = Digital input 2 on
OFF = Digital input 3 off
R
ON = Digital input 3 on
OFF = Digital input 4 off
R
ON = Digital input 4 on
R/W
Status (STATUS_W)
See: Table of digital input functions
See: Table of digital input functions
See: Table of digital input functions
See: Table of digital input functions
Table of software shutdown methods
Outputs rL.1- rL.2 - rL.3 - rL.5 = OFF
0 Outputs rL.4 - rL.6 = ON
Alarms AL.1 -AL.2 -AL.3 - AL.4 disabled
Outputs rL.1- rL.2 - rL.3 - rL.5 = OFF
1 Outputs rL.4 - rL.6 = ON
Alarms AL.1 -AL.2 -AL.3 - AL.4 enabled
See: Table of state setting
0
0
0
0
0
0
55