Status (Status_W); Manual Power Correction; Mains Voltage - gefran GPC Configuration And Programming Manual

3.22.3.

Status (STATUS_W)

Address
Format
Single- Multi-
node node
1329
2353 305 16 bit
4401
The parameter sets the Automatic/Manual and Software startup/shutdown operating status of the controller with bits.
Options:

3.23. Manual power correction

In manual operation, the power output can be corrected
automatically in relation to the reference mains voltage (riF).
The% correction value (Cor) is freely adjustable and acts in
an inversely proportional manner, i.e., if the reference volt-
age increases, the power output decreases, and vice versa.
The function is switched on and off via the SP.r parameter.
3.23.1.

Mains voltage

Address
Format
Single- Multi-
node node
1529
2553
505 16 bit
4601
The parameter sets the reference mains voltage, i.e., the voltage value against which the actual voltage is compared in order to keep the
output power constant.
min...max: 0.0...999.9
3.23.2. Manual power correction
Address
Format
Single- Multi-
node node
1530
2554 506 16 bit
4602
The parameter sets the manual power correction depending on the mains voltage.
The maximum manual power correction is limited to ± 65%.
min...max: 0.0...100.0
GPC-OP
Acronym
menu
07.02.14 M
STA-
07.03.14 E1
TUS_W
01.04.14 E2
bit
3
4
GPC-OP
Acronym
menu
07.02.07 M
07.03.07 riF E1
01.04.07 E2
GPC-OP
Acronym
menu
07.02.08 M
07.03.08 Cor E1
01.04.08 E2
81901 "MSW_GPC-40/600A"_03-2021_ENG_page 102
GF_eXpress menu
Description
MainMenu → M → Controls →
STATUS_W_1
MainMenu → E1 → Controls →
STATUS_W_2
MainMenu → E2 → Controls →
STATUS_W_3
Status setting
ON/OFF selection
AUTO/MAN selection
In addition to the parameters explained below, the STA-
TUS_W parameter should also be considered in manual
power correction (see paragraph "3.22.3. Status (STA-
TUS_W)".
When moving from AUTO to MAN mode, sudden output
changes are possible.
GF_eXpress menu
Description
MainMenu → M → Controls → riF_1
MainMenu → M → Controls → riF_2
MainMenu → M → Controls → riF_3
GF_eXpress menu
Description
MainMenu → M → Controls → Cor_1
MainMenu → E1 → Controls → Cor_2
MainMenu → E2 → Controls → Cor_3
Unsigned
■
R/W
Short
Float
■
R/W V
(####.#)
Float
■
R/W %
(####.#)
0
0.0
0.0