Alarm Memory Reset; Alarm Status (Alstate_Irq) - gefran GPC Configuration And Programming Manual

3.13.13.

Alarm memory reset

Address
Format
Single- Multi-
node node
1103
2127 79 bit
4175
The parameter allows the memory of all generic alarms to be cleared by changing the state of the bit.
To clear the memory of a specific generic alarm, see parameters dIG.1, dIG.2, dIG.3 and dIG.4 for alarms 1, 2, 3 and 4 respectively.
OFF = No function
Options:
ON = Generic alarms AL1...AL8 are reset
3.13.14.

Alarm status (ALSTATE_IRQ)

Address
Format
Single- Multi-
node node
1342
2366 318 16 bit
4414
The parameter shows the status of generic alarms AL1...AL8 and HB / POWER_FAULT alarms. Bit = 0 indicates the alarm is not active, bit
= 1 indicates the alarm is active.
The following table shows the correspondence between bit and individual alarms.
Options:
bit
0
1
2
3
4
5
6
7
8
9
10
11
GPC-OP
Acronym
menu
12.01.03 M
BIT_
RESET_
12.02.03 E1
AL1_AL8
12.03.03 E2
GPC-OP
Acronym
menu
M
AL-
STATE_ E1
IRQ
E2
Alarm status AL1
Alarm status AL2
Alarm status AL3
Alarm status AL4
Alarm status AL.HB (or phases 1/2/3 if three-phase) or POW-
ER_FAULT
Alarm status AL.HB phase 1 (with three-phase load)
Alarm status AL.HB phase 2 (with three-phase load)
Alarm status AL.HB phase 3 (with three-phase load)
Alarm status AL5
Alarm status AL6
Alarm status AL7
Alarm status AL8
81901 "MSW_GPC-40/600A"_03-2021_ENG_page 58
GF_eXpress menu
Description
MainMenu → M → Expert →
Bit → BIT_RESET_AL1_AL8_1
MainMenu → E1 → Expert →
Bit → BIT_RESET_AL1_AL8_2
MainMenu → E2 → Expert →
Bit → BIT_RESET_AL1_AL8_3
GF_eXpress
Description
MainMenu → M → Status →
ALSTATE_IRQ_1
MainMenu → E1 → Status →
ALSTATE_IRQ_2
MainMenu → E2 → Status →
ALSTATE_IRQ_3
Description
■
R/W
R
Alarm type
Generic alarm
Generic alarm
Generic alarm
Generic alarm
Heater Break Alarm
/ POWER_FAULT
Heater Break Alarm
Heater Break Alarm
Heater Break Alarm
Generic alarm
Generic alarm
Generic alarm
Generic alarm