On.of - Enabling Software On/Off - gefran 650 Installation And Instruction Manual

4. CONFIGURATION

4.19.5. On.OF - Enabling software on/off

Acronym
On.OF SOFTWARE ON/OFF ENABLE
The parameter shows and sets enabling of on/off of the controller's software.
The software ON-OFF function is explained in detail in paragraph "5.8. Switching the software on/off" on page <?>.
Unit of measurement:
Options: ENABL = Controller software on/off enabled
DISAB = Controller software on/off disabled
4.19.6. MA.P.L - Enabling manual power latch
Acronym
MA.P.L MANUAL POWER LATCH ENABLE
The parameter shows and sets enabling of memorization (in non-volatile memory) of the manual power value.
Unit of measurement:
Options: LATCH = Latch enabled
NO.LAT = Latch disabled. After Power-on, Manual power value is reset
4.19.7. MAn.P - Enabling change of manual power value
Acronym
MAn.P MANUAL POWER MODIFY ENABLE
The parameter shows and sets enabling of change of the manual power value.
Unit of measurement:
Options: MODIF
NO.MOD = Change not allowed
4.19.8. dIG - Defining type of digital inputs
Acronym
dIG DIGITAL INPUT TYPE
The parameter shows and sets the type of digital inputs.
Unit of measurement:
Options: NPN
PNP
4.19.9. ALRM.N - Number of alarms enabled
Acronym
ALRM.N NUM OF ENABLE ALARMS
The parameter shows and sets the number of alarms enabled.
No alarm is enabled if the parameter equals "0".
Unit of measurement:
Options: 0...4
112
Scrolling message
-
Scrolling message
-
Scrolling message
-
= Change allowed
Scrolling message
-
= NPN digital inputs or voltage-free contact
= PNP digital inputs
Scrolling message
Number
Submenu
MODE
Submenu
MODE
Submenu
MODE
Submenu
MODE
Submenu
MODE
80208G_MHW_650-1250-1350_01-2017_ENG
Attributes
R W
Attributes
R W
Attributes
R W
Attributes
R W
Attributes
R W