Table of Contents
Advertisement
5.3.
Operations
5.3.1.
HOME screen
E2
V
230 230
A
200 200
KW
46
The screen gives a summary of the basic GPC parameters:
•
voltage on the load (V),
•
current in the load (A)
•
power on load (KW)
of the three modules.
The screen is displayed:
•
with the GPC is switched on (keypad already connect-
ed),
•
when connecting the keypad to the GPC (in the ab-
sence of alarms),
•
by pressing the HOME button.
5.3.2.
Accessing the menu
To access the menu, press the MENU button.
The keypad checks whether a password has been set (con-
figurable via GF_eXpress).
If the password has not been enabled (PASS.C = 0), the
menus are accessed directly.
If the password is enabled (PASS.C > 0), it displays the
screen on which to enter the numeric password (PASS-
WORD = PASS.C) which allows access to the menus, if the
value entered is correct.
02.01
PASSWORD:
Def:
0
If the password entered is incorrect, you return to HOME.
The entered password will remain valid until the GPC-OP is
disconnected from the GPC or the HOME or ALARM button
is pressed.
For instructions on changing your password, see paragraph
"5.3.5. Changing a numerical parameter".
5.3.3.
Browsing the menus
Press the ► key to enter the submenu or parameter. The
same result is obtained by pressing the ENTER key.
Press the ► key twice to return to the main menu.
Press the ▼ and ▲ keys to scroll through the various menu
items.
E1
M
230
200
46
46
ADDR: 10 - 889
0
81901 "MSW_GPC-40/600A"_03-2021_ENG_page 142
Each menu item is preceded by a numerical address with
2-digits (1st level menu), 4-digits (2nd level menu) or 6-dig-
its (3rd level menu). The address digits are grouped in twos
and separated by a dot.
04.01 STATUS M
04.02 STATUS E1
04.03 STATUS E2
04.04 ANALOG In.A1
04.05 ANALOG In.A2
In the above screenshot, the parameter ANALOG In.A2 has
address 04.05, i.e., the fourth item in the first-level menu
and the fifth item in the corresponding second-level menu.
5.3.4.
Parameter display
1
04.04.01
Tp.A1: input type
3
Def:
1
5
1.
Indication of menu index and parameter position.
2.
Modbus address of the parameter in node - address
format (in the image node = 10, address = 573).
3.
Parameter description.
4.
Parameter value:
• Numerical parameter: the numerical value of the pa-
rameter is displayed in the required format, together
with the unit of measurement.
• Binary parameter: the 16 data bits are displayed in
succession by pressing the ►key.
• Status parameter (COMMANDS menu): the status
description is displayed.
5.
Additional information depending on the type of pa-
rameter:
• Numerical parameter: the default, minimum and
maximum values of the parameter are displayed.
These values are shown in sequence by pressing the
► button (only if the parameter is R/W).
When setting the R/W parameter, any Out of range
error condition of the entered value is shown.
• Binary parameter: displays the status (ON-OFF,
AUTO-MAN, ...) of the bits selected in sequence by
pressing the ►key.
2
ADDR: 10 - 573
1
4
Advertisement
Table of Contents
