Table of Contents
Advertisement
Pre-Start Inspection
The Pre-Start Inspection should include each of the following:
1. Cleanliness – Check all surfaces for leakage, debris or
foreign objects.
2. Decals and Placards – Check all for cleanliness and
legibility. Make sure none of the decals and placards
are missing. Make sure all illegible decals and placards
are cleaned or replaced. (Reference Section 5.3, DECAL
REPLACEMENT and Section 5.4, DECAL INSTALLA-
TION).
3. Operation, Safety Service & Maintenance Manual –
Make sure a copy of the Operation, Safety, Service &
Maintenance Manual, AEM Safety Manual, and ANSI
Manual of Responsibilities is enclosed in the weather
resistant storage container.
4. Assembly – The machine must be fully assembled in
accordance with Section 3.3.
5. Walk-Around Inspection – Refer to Section 2.3.
6. Powerpack – Charge as required (Section 3.6).
7. Function Check – Once the Walk-Around Inspection is
complete, perform a function check of all systems in
an area free of overhead and ground level obstruc-
tions. Refer to Section 2.4 for more specific instruc-
tions.
3121296
SECTION 2 - PREPARATION AND INSPECTION
2.3
DAILY WALK-AROUND INSPECTION
Begin the Walk-Around Inspection at item one (1) as noted on
the diagrams Figure 2-2. and Figure 2-3. Continue around
machine checking each item in sequence for the conditions
listed in the following check list.
TO AVOID POSSIBLE INJURY, BE SURE DIRECTION SELECTOR IS IN THE "OFF"
POSITION DURING WALK-AROUND INSPECTION.
DO NOT OPERATE MACHINE UNTIL ALL MALFUNCTIONS HAVE BEEN COR-
RECTED.
NOTE: Do not overlook visual inspection of the base frame
underside. Check this area for objects, debris, corrosion
and cracks.
Walk-Around Inspection Components
INSPECTION NOTE: On all components, make sure there are no
loose or missing parts, everything is securely fastened, no
visible damage, or excessive wear exists in addition to
any other criteria mentioned.
1. Rear Wheels - Check for any debris stuck to or around
wheels. Make sure axle bolts are fastened.
2. Base Frame - Check for cracks or corrosion, especially
around the mast-stump base (see Figure 2-1.). Check
LIFTPOD by JLG
2-3
Advertisement
Table of Contents
