Configuring Data Transfer To The Emr System - Seca mVSA 535 Instructions For Use Manual

6.4 Configuring data transfer to the EMR system

5. Specify the settings for the scan sequence for user and patient ID:
►
Sequence for ID scan fixed: 1. User, 2. Patient
►
Sequence for ID scan flexible
6. Specify whether measurements are to be possible even if the connection
to the EMR system is interrupted (offline measurements):
►
Do not allow offline measurement
►
Allow offline measurements
NOTE
Offline measurements are temporarily saved in the Unsubmitted
measurements list. When the connection to the EMR system is
active again, the measurements can be called up, evaluated and sub-
mitted to the EMR system ➔
list.
7. Under User-ID, specify whether a password is required for login:
► Password must be entered (recommended)
► No password required
8. If desired, enter an Organization ID to assign the device to a department
in your institution, for example.
9. Adopt the settings:
a) Press the
b) Press the
The settings are saved.
seca recommends performing the data transfer to the EMR system only in
collaboration with seca Service and the manufacturer of your EMR system.
NOTE
More information on this can be found in the
instructions for use (from version 2.0 or higher).
Using the Unsubmitted measurements
button
button
seca 103/452
Connecting to an EMR system • 153
English
system