Seca mVSA 535 Instructions For Use Manual page 44

44 •
seca mVSA 535
NOTE
Get the patient to sit quietly for 5 minutes before recording measured
values. The patient should remain relaxed and not talk during the
measurement.
You have the following options for continuing:
► ➔
Starting a single measurement
► ➔
Starting a multiple measurement
NOTICE!
Faulty operation, missing measuring results
Results from multiple measurements cannot be transmitted to EMR
systems or the
seca analytics 115
► Switch to Single measurement, if necessary, if you want to transmit
blood pressure values to an EMR system or the
PC software ➔
NOTE
Your administrator will specify whether Single measurement or Multi-
ple measurement is available when the device starts up. You can
modify this and other presets for the current measurement procedure:
➔
Modifying presets. After this, the settings specified by the adminis-
trator will be active again.
Starting a single measurement
► Press the
button on the monitor.
Blood pressure measurement starts:
Current cuff pressure is displayed.
The symbols for measurement procedure and measuring mode flash (in
this case: Single measurement, inflation).
Measurement stops automatically as soon as valid blood pressure values
are detected.
The values for systolic/diastolic blood pressure SYS/DIA are displayed.
► Measure more vital signs ➔
► Stop the measurement procedure ➔
procedure
NOTE
• Using the Start button, you can cancel and restart blood pressure
measurement at any time.
• If inflation fails to deliver a measured value, the device automatically
switches to deflation. If necessary, the device re-pumps several
times during the deflation (re-pumping: Increasing cuff pressure by
approx. 50 mmHg followed by incremental releasing of that pres-
sure). If no measured value is delivered even after several re-pump-
ing steps, the procedure is canceled.
PC software.
Modifying presets.
Measuring vital signs
Stopping a measurement
seca analytics 115