GRAPHTEC GLT400 User Manual page 5

Do not use or store the GLT400 in a location exposed
to direct sunlight or the direct draft of an air
conditioner or heater.
•
Such location may impair the
GLT400's performance.
Use prohibited
Do not use the GLT400 in a location subject to
excessive mechanical vibration or electrical noise.
•
Such location may impair the GLT400's performance.
Use prohibited
If fluid or foreign matters enters inside the GLT400,
turn off the power switch and disconnect the power
cord from the electrical socket.
•
Use in such status may cause a fire hazard due to electrical
shock or current leakage.
•
Contact your sales representative or
nearest Graphtec vendor to request
repair.
Unplug the power
cord from the socket
Do not attempt to lubricate the GLT400's mechanisms.
•
Such action may cause the GLT400 to break down.
Use prohibited
Be sure to use the Graphtec-supplied AC adapter.
•
It will damage this device.
Use prohibited
Safety Precautions
CAUTION CAUTION
Do not place the receptacles containing fluid onto this
device or close to this device.
•
To insert or disconnect the power cord or a signal
input cable, grasp the power cord's plug or the signal
input cable's connector.
•
Do not use the AC power supply and the DC power
supply other than the specified supply voltage for this
device.
•
Never clean the GLT400 using a volatile solvent (such
as thinner or benzine).
•
•
Fluid spilling inside the GLT400 may cause a fire hazard
due to electrical shock or current leakage.
Watch out for
Avoid water
electrical shock
Pulling the cord/cable itself damages the cord/cable,
resulting in a fire hazard or electrical shock.
Use prohibited
Such action may cause a fire hazard due to electric shock
or current leakage.
Use prohibited
Such action may impair the GLT400's performance.
Clean off any soiled areas using a soft dry cloth.
Use prohibited
Safety Precautions
iii