Table of Contents
Advertisement
4.5 Monitor Screen
The digital value of the GLT400 input signal, capturing status, capturing control, alarm display, alarm clear,
pulse clear and error description can be checked.
(1)
(9)(10)
(11)
Selection Item
(1) Status
(2) Screen update rate
(3) Alarm
(4) Alarm clear
(5) Clear pulse
(6) Capturing start
(7) Capturing stop
(8) Error log
(9) CH number
(10) Annotation
(11) Measurement value
(2)
Displays the capturing status of the GLT400.
Item
Free running
Displayed when the power is turned on or capturing is not performed.
Waiting for trigger
Displayed when waiting for the trigger establishment after the measurement
starts.
Trigger detection
Displayed when the trigger is established.
Capturing in internal
Displayed when data is being captured in the internal memory.
memory
Capturing in SD CARD
Displayed when data is being captured in the SD CARD.
Capturing stop
Displayed when capturing is stopped.
Data capturing finished
Displayed when data capturing is finished and waiting for capturing stop.
Writing
Displayed when capturing stop process is being executed.
Set the screen update rate.
500 ms, 1 s, 2 s, 5 s, 10 s
It is not linked to the sampling interval. When the sampling interval is 1 sec, the same data will be
acquired at 2 points even if the update rate is set to 500ms.
Displays the alarm output status. The number where the alarm is output is displayed in red.
The output alarm is cleared. It is activated only when "Hold alarm" is enabled.
The accumulated value of the pulse is cleared. This is enabled only when the pulse input is set to
Accumulation.
Capturing is started.
Capturing is stopped.
Displays the error log.
Displays the CH number of the input signal.
Displays the annotation string of the input signal.
Displays the measured value.
(3)
(4)(5)
(6)
Description
CHAPTER 4 Settings and Measurement
(7)
(8)
Description
4-49
Advertisement
Table of Contents
