value to be changed will flash. To accept the new set-
ting, press [OK], to abort, press [CANCEL].
Manual initialization
The adjustable frequency drive can be initialized to
factory settings in two ways.
Initialization by parameter 620
- Recommended initialization
•
Select parameter 620
•
Press [CHANGE]
•
Select "Initialization"
•
Press the [OK] key
•
Cut off the mains supply and wait until the
display turns off.
•
Reconnect the mains supply - the adjustable
frequency drive is now reset.
This parameter initializes all except:
500
Serial communication address
501
Baud rate for serial communication
601-605
Operating data
615-617
Fault logs
Manual initialization
•
Disconnect from mains and wait until the dis-
play turns off.
•
Press the following keys at the same time:
[Display/status]
[Change data]
[OK]
•
Reconnecting the mains supply while press-
ing the keys.
•
Release the keys
•
The adjustable frequency drive has now
been programmed for the factory setting.
This parameter initializes all except:
600-605
Operating data
NOTE
Settings for serial communication and
fault logs are reset.
MG.51.C5.22 - VLT
is a registered Danfoss trademark.
®
VLT
5000 Series
77