Danfoss VLT 5000 Series Instruction Manual page 32

Compact, AC line supply 3 x 550-600 V
According to international requirements
Normal overload torque (110 %):
Output current
Output
Typical shaft output P
Typical shaft output P
High overload torque (160 %):
Output current
Output
Typical shaft output P
Typical shaft output P
Max. cross-section of copper cable to motor, brake
and loads haring [mm
AWG
Max. cross-section of copper cable to motor, brake
and loads haring [mm
AWG
Min. cable cross-section to motor, brake and load
sharing
AWG
1. For type of fuse, see section Fuses.
2. American Wire Gauge.
3. Measured using 100 ft [30 m] shielded motor cables at rated load and rated frequency.
4. Min. cable cross-section is the smallest cable cross-section allowed to be fitted on the terminals. Always comply
with national and local regulations on min. cable cross-section.
5. Connection stud 1 x M8/2 x M8.
MG.51.C5.22 - VLT is a registered Danfoss trademark.
I
VLT,N
I (60 s) [A] (550 V) 221
VLT, MAX
I
VLT,N
I (60 s) [A] (575 V) 211
VLT, MAX
S
VLT,N
S
VLT,N
[kW]
VLT,N
[HP]
VLT,N
I
VLT,N
I (60 s) [A] (550 V) 242
VLT, MAX
I
VLT,N
I (60 s) [A] (575 V) 230
VLT, MAX
S
VLT,N
S
VLT,N
[kW]
VLT,N
[HP]
VLT,N
2
]
2
]
4) 2
[mm ]
®
VLT 5000 Series
VLT type 5150
[A] (550 V) 201
[A] (575 V) 192
[kVA] (550 V) 191
[kVA] (575 V) 191
132 160
200 250
[A] (550 V) 151
[A] (575V) 144
[kVA] (550 V) 144
[kVA] (575 V) 143
110 132
150 200
2x120 2x120
2x4/0 2x4/0
2x185 2x185
2x300 mcm 2x300 mcm
2x6 2x6
2x8 2x8
5200 5250
253 289
278 318
242 289
266 318
241 275
241 288
200
300
201 253
322 405
192 242
307 387
191 241
191 241
160
250
2x120
2x4/0
2x185
2x300 mcm
2x6
2x8
29