Danfoss VLT 5000 Series Instruction Manual page 33

Compact AC line supply 3 x 550-600 V
According to international requirements
Max input current 110%
Max input current 160%
Max. cross-section of copper cable to power [mm
Max. cross-section of aluminum cable to power [mm
Max. cross-section of copper cable to power [AWG]
Max. cross-section of aluminum cable to power [AWG]
Min. cable cross-section to motor, brake and load shar-
ing
Max. pre-fuses (line power) [-]/UL
Integral pre-fuses (softcharge circuit) [-]/UL
Integral pre-fuses (softcharge resistors) [-]/UL
Integral pre-fuses (SMPS) [-]/UL
Efficiency
Weight IP 00
Weight Nema 1 EB
Power loss at max. load [W]
Enclosure
1. For type of fuse, see section Fuses.
2. American Wire Gauge.
3. Measured using 100 ft [30 m] shielded motor cables at rated load and rated frequency.
4. Min. cable cross-section is the smallest cable cross-section allowed to be fitted on the terminals. Always comply
with national and local regulations on min. cable cross-section.
5. Connection stud 1 x M8/2 x M8.
6. If UL/cUL is to be complied with, AC Littelfuse type KLK, Danfoss ordering no. 176F1147 must be used.
7. If UL/cUL is to be complied with, DC Littelfuse type KLKD, Danfoss ordering no. 176F1192 must be used.
8. If UL/cUL is to be complied with, Bussmann type KTK-5, Danfoss ordering no. 175L3437 must be used.
30
I
L,MAX
I
L,MAX
4) 2/ 2) 5)
[mm AWG]
®
VLT 5000 Series
VLT type
I [A] (550 V)
L,MAX
I [A] (575 V)
L,MAX
[A] (550 V)
[A] (575 V)
2
] 2 x 120
2
] 2 x 185
2 x4/0
2
mcm
6/8
1)
250
[A]
6)
[A] 30/30
7)
12/12
[A]
8)
5
[A]
0.96-0.97
[kg]
[kg]
5030
MG.51.C5.22 - VLT is a registered Danfoss trademark.
5150 5200 5250
196 246 281
179 226 270
147 196 246
134 179 226
2 x 120 2 x 120
2 x185 2 x 185
2 x4/0 2 x4/0
x 300 2 x 300 2 x 300
mcm mcm
6/8 6/8
350 400
30/30 30/30
12/12 12/12
5 5
146 146 146
161 161 161
6340 7570
IP 00/Nema 1 (IP 20)