Restoring Default Settings; Recommended Initialization; Manual Initialization; Basic Operational Programming - Danfoss VLT Decentral Drive FCD 302 Operating Manual

VLT® Decentral Drive FCD 302
Operating Guide

5.3.6 Restoring Default Settings

RISK OF LOSING DATA
When restoring default settings, there is a risk of losing programming, motor data, localization, and monitoring records.
-
Provide a back-up by uploading data to the LCP before initialization.
Restoring the default parameter settings is done by initialization of the drive. Initialization is carried out via parameter 14-22 Opera-
tion Mode (recommended) or manually.
•
Initialization via parameter 14-22 Operation Mode does not reset the drive settings such as hours run, serial communication se-
lections, personal menu settings, fault log, alarm log, and other monitoring functions.
• Manual initialization erases all motor programming, localization, and monitoring data, and restores factory default settings.

5.3.6.1 Recommended Initialization

Procedure
1.
Press [Main Menu] twice to access parameter.
2.
Scroll to parameter 14-22 Operation Mode and press [OK].
3.
Scroll to [2] Initialisation and press [OK].
4. Remove power to the unit and wait for the display to turn off.
5. Apply power to the unit.

Default parameter settings are restored during start-up. This may take slightly longer than normal.
6.
Alarm 80, Drive initialised is shown.
7. Press [Reset] to return to operating mode.

5.3.6.2 Manual Initialization

Procedure
1.
Remove power to the unit and wait for the display to turn off.
2. Press and hold [Status], [Main Menu], and [OK] at the same time while applying power to the unit (approximately 5 s or until
a click is heard and the fan starts).

Factory default parameter settings are restored during start-up. This might take slightly longer than normal.
Manual initialization resets parameter settings except for the settings in:
•
Parameter 15-00 Operating Hours.
•
Parameter 15-03 Power Up's.
•
Parameter 15-04 Over Temp's.
•
Parameter 15-05 Over Volt's.

5.4 Basic Operational Programming

Drives require basic operational programming before running for best performance. Basic operational programming requires enter-
ing motor nameplate data for the motor being operated and the minimum and maximum motor speeds. Enter the data in accord-
ance with the following procedure. See
with power ON, but before operating the drive.
1. Press [Quick Menu] on the LCP.
2.
Use the navigation keys to scroll to parameter group Q2 Quick Setup and press [OK].
38 | Danfoss A/S © | 2020.07
N O T I C E
5.3.2 LCP Layout for detailed instructions on entering data through the LCP. Enter the data
Commissioning
AQ267036816112EN-000101 / 130R0208