Danfoss VLT 5000 Series Instruction Manual page 116

304 Terminal 27, input
(DIGITAL INPUT 27)
Value:
See parameter 300.
Function:
This parameter allows a choice between the different
options on terminal 27.
Functions are shown in the table at the beginning of
the section Parameters - Inputs and Outputs.
Maximum frequency for terminal 27 is 5 kHz.
Description of choice:
See parameter 300.
305 Terminal 29, input
(DIGITAL INPUT 29)
Value:
See parameter 300.
Function:
This parameter allows a choice between the different
options on terminal 29. The functions are shown in the
table at the beginning of the section Parameters - In-
puts and Outputs.
Maximum frequency for terminal 29 is 65 kHz.
Description of choice:
See parameter 300.
Analog inputs
Value:
No operation
Reference
Feedback signal
Torque limit
Thermistor
Relative reference
Max. torque frequency
= factory setting, () = display text, [] = value for use in communication via serial communication port
MG.51.C5.22 - VLT is a registered Danfoss trademark.
306
Value:
See parameter 300.
Function:
This parameter allows a choice between the different
options on terminal 32. The functions are shown in the
table at the beginning of the section Parameters - In-
puts and Outputs.
Maximum frequency for terminal 32 is 65 kHz.
Description of choice:
See parameter 300.
307
Value:
See parameter 300.
Function:
This parameter allows a choice between the different
options on terminal 33. The functions are shown in the
table at the beginning of the section Parameters - In-
puts and Outputs.
Maximum frequency for terminal 33 is 65 kHz.
Description of choice:
See parameter 300.
terminal no. 53(voltage)
parameter 308
(NO OPERATION) [0]
(REFERENCE)
[1]
(FEEDBACK) [2]
(TORQUE LIMIT CTRL) [3]
(THERMISTOR INPUT) [4]
(RELATIVE REFERENCE)
(MAX. TORQUE FREQ.)
®
VLT 5000 Series
Terminal 32, input
(DIGITAL INPUT 32)
Terminal 33, input
(DIGITAL INPUT 33)
54(voltage) 60(current)
311 314
[0]
[0]
[1]
[1]
[2]
[2] [3]
[3]
[4] [4]
[5]
113