Static Ip Address Configuration-Windows 7; Confirming Ethernet Setup - Novatel SMART7 Installation And Operation Manual

Chapter 6 Ethernet Configuration
LOG IPCONFIG ONCE
8. Configure your computer with a static IP address.
Refer to Static IP Address Configuration—Windows 7 below.
6.2.2 Static IP Address Configuration—Windows 7
Follow these steps to set up a static IP address on a computer:
1. Click Start | Control Panel.
2. Click Network and Sharing Center.
3. Click the Local Area Connection link.
The Local Area Connection Status window appears.
4. Click the Properties button.
The Local Area Connection Properties window appears.
5. Select Internet Protocol Version 4 (TCP/IPv4) and then click the Properties button.
The Internet Protocol Version 4 (TCP/IPv4) Properties window appears.
6. Click the Use the Following IP Address radio button, then enter the IP address, Subnet
mask and Default gateway for the Ethernet port on the computer.
Ensure the Ethernet settings used for the computer are compatible with the
Ethernet settings on the OEM7 receiver.
For example, the following settings are compatible with the OEM7 receiver
settings used in Static IP Address Configuration—Receiver on the previous page:
7. Click the OK button.
The Local Area Connection Properties window appears.
8. Click the Close button.
The Local Area Connection Status window appears.
9. Click the Close button.
10. Proceed to Confirming Ethernet Setup below.

6.2.3 Confirming Ethernet Setup

1. Connect the computer to the OEM7 receiver using an Ethernet cross-over cable.
See Figure 31: Cross-Over Ethernet Cable Configuration—OEM7 Receiver on the previous
page.
2. Connect to the receiver using NovAtel Connect or any third party terminal program that sup-
ports TCP/IP connections. Use the static IP address and port number assigned to the OEM7
receiver in Static IP Address Configuration—Receiver on the previous page.
NovAtel Connect version 2.0 or greater is required for OEM7 receivers. Download
the latest NovAtel Connect software and documentation from
www.novatel.com/novatel-connect.
SMART7 Installation and Operation User Manual 0C
IP address = 192.168.74.11
Subnet mask = 255.255.255.0
Gateway = 192.168.74.1
93