Advertisement
(5) Origin setting procedure
Do the following operations with pressing the enabling switch of T/B lightly.
<MENU>
1.FILE/EDIT
3.PARAM.
5.SET/INIT.
123
<ORIGIN/BRAKE>
1.ORIGIN
123
<ORIGIN>
1.DATA
3.TOOL
5.USER
123
<ABS>
J1:(
1
)J2:(
0
J4:(
0
)J5:(
0
J7:(
0
)J8:(
0
REL.
123
<ORIGIN> ABS
CHANGE TO ORIGIN. OK?
Yes
123
<ABS>
J1:(
1
)J2:(
J4:(
0
)J5:(
J7:(
0
)J8:(
REL.
123
The origin settings are completed.
CAUTION
CAUTION
2.RUN
4.ORIGIN/BRK
6.ENHANCED
CLOSE
2.BRAKE
CLOSE
2.MECH
4.ABS
CLOSE
)J3:(
0
)
)J6:(
0
)
)
CLOSE
No
0
)J3:(
0
)
0
)J6:(
0
)
0
)
CLOSE
After setting the origin, when the joint coordinates of the ABS mark position deviate
from the coordinates of the ABS origin by 1.5° or more, align the end points of the
ABS marks and set the origin using the ABS origin method again.
When the ABS mark label of the axis other than the J6 axis is peeled off, align the
pinholes used to set the origin with the jig method. The joint coordinates are the same
between the ABS origin method and the jig method.
1) Press the [4] key on the menu screen, and dis -
play the Origin/Brake selection screen.
2) Press the [1] key, and display the Origin setting
selection screen.
3) Press the [4] key, and display the ABS selection
screen.
4) Input "1" into the axis to origin setting. Press
the [EXE] key, and display Confirmation screen.
Note) Always perform origin setting of the J5
axis and the J6 axis simultaneously.
→
5) Press the [F1] key, and the origin position is set
up.
5 Maintenance and Inspection
Resetting the origin 5-179
Advertisement
