Advertisement
(2) RV-2FRL/2FRLB
<1> Tape
①テープ
The fork insertion
フォークリフトの爪
挿入口
slots for a forklift truck
Fig.2-2 ： Unpacking the robot arm (RV-2FRL/2FRLB)
The robot is shipped from the factory in cardboard and plywood packing. Always refer to
robot. Handle the robot arm according to
CAUTION
The unpacking process is shown below.
1) Using a knife, etc., slit the tape <1> fixing the upper lid <2> of the cardboard box.
2) Pull the upper lid <2> of the cardboard box off with both hands.
3) Remove the hexagon socket bolts <3> (four positions) connecting the sleeper and the base unit.
(c))
[Note] Do not remove the fixing plate A, B, and C until installation finishes. Always attach the fixing plates while
transporting the robot.
CAUTION
<2>
Upper lid
②上ブタ
Knobs for manual transportation
人手運搬用取っ手
(Also provided on the opposite side)
（反対側にもあり）
（ａ）
ロボット本体
Robot arm
（ｃ）
"2.2.2Transportation procedures (Transportation by
Always unpack the robot at a flat place. The robot could tilt over if unpacked at an
unstable place.
When repackaging the robot in the wooden frame, always use the fixing plates.
Pull out
引き抜く
（ｂ）
!
CAUTION
!
Always unpack the
robot at a flat place.
The robot could tilt
over if unpacked at an
unstable place.
Notes) The packing material is required at re-transportation.
Please keep it with care.
(Fig. 2-2
2Unpacking to Installation
CAUTION
!
!
An unopened package
shall be transported
by a forklift truck or
by manually
(with two workers).
Fig. 2-2
and unpack the
people)".
(Fig. 2-2
(a))
(b))
(Fig. 2-2
Installation 2-11
Advertisement
