Profinet Module (Cbe20); Adding Online Into The Drive; Adding Offline In Starter - Siemens SINAMICS DCM Operating Instructions Manual

8.6.3

PROFINET module (CBE20)

8.6.3.1

Adding online into the drive

The CBE20 is automatically detected when plugged into the slot and is integrated into the
system.
Before the module can also be addressed in the network, an IP address and device name
must be assigned; refer to the Chapter "Function descriptions", Section "PROFINET IO".
Note:
If PROFINET is to be used only as a commissioning interface but process control is through
PROFIBUS, after commissioning the CBE20 the process data interface needs to be set back
to PROFIBUS (p8839=1).
8.6.3.2

Adding offline in STARTER

Figure 8-40
SINAMICS DCM DC Converter
Operating Instructions, 1.2012, C98130-A7066-A1-05-7619
Configuration
8.6 Commissioning optional additional modules
Commissioning
271