Siemens SINAMICS DCM Operating Instructions Manual page 167

Memory Card slot
Figure 6-50
CAUTION
 The Memory Card may only be inserted as shown in the figure above.
 The Memory Card must not be removed or inserted while data is being saved.
 If you are returning a defective module (C98043-A7100 (CUD)), do not return the
No Memory Card is required to operate the CUD.
The Memory Card is needed in the following applications:
● Saving parameters
● Software update
● Loading additional languages onto the Advanced Operator Panel AOP30.
● Performing an offline long-time trace
● Loading the DCC block library into the drive
● SINAMICS Link function: The SINAMICS Link function requires that the memory card is
SINAMICS DCM DC Converter
Operating Instructions, 1.2012, C98130-A7066-A1-05-7619
Module C98043-A7100 CUD, slot for Memory Card
Procedure to safely remove the memory card, see Chapter "Operation", Section
"Memory card functions".
Memory Card along with it - instead, keep it so that you can use it in the replacement
module.
Parameters are saved on the Memory Card and can simply be copied onto a new CUD if
it needs to be replaced.
A software update is easy to carry out using a Memory Card.
always inserted.
6.9 Assignment of terminals and connectors
Connecting
165