Siemens SINAMICS DCM Operating Instructions Manual page 378

Dc converter

Hide thumbs Also See for SINAMICS DCM:

Table of Contents

Descriptions of functions

10.3 PROFINET IO

DCP flashing

This function is used to check whether assignments to a module and its interfaces have

been made correctly.

1. In HW Config or STEP7 Manager, select the menu command "Target system" >

2. The "Edit Ethernet Node" dialog box opens.

3. Click the "Browse" button.

4. The "Browse Network" dialog box opens and displays the connected nodes.

5. After SINAMICS with CBE20 has been selected as a node, activate the "DCP flashing"

The "DCP flashing" function is activated on the RDY LED (READY LED 2 Hz, green/orange

or red/orange) on the CUD.

The LED will continue to flash as long as the dialog is open. When the dialog is closed, the

LED will go out automatically. The function is available as of STEP7 V5.3 SP1 via Ethernet.

STEP 7 routing with CBE20

The CBE20 does not support STEP 7 routing between PROFIBUS and PROFINET IO.

"Ethernet" > "Edit Ethernet node".

function by means of the "Flash" button.

Operating Instructions, 1.2012, C98130-A7066-A1-05-7619

SINAMICS DCM DC Converter