Menu: Commissioning/Service; Drive Commissioning; Device Commissioning - Siemens SINAMICS DCM Operating Instructions Manual

9.3.5

Menu: Commissioning/Service

9.3.5.1

Drive commissioning

Selecting this option enables you to re-commission the drive from the main menu, using the
AOP wizard.
Basic commissioning
A few key parameters (such as the maximum speed, ramp-up time, and ramp-down time)
are requested. The changes can then be permanently saved in the final confirmation screen.
Complete commissioning
Complete commissioning, with entry of the motor and encoder data, is carried out. Following
this, key motor parameters are recalculated on the basis of the motor data. The parameter
values calculated during the previous commissioning process are lost. The calculated values
are then overwritten during a subsequent optimization run.
Optimization run
The selection screen for the optimization runs appears.
9.3.5.2

Device commissioning

In this menu, you can enter the device commissioning status directly. This is the only way
that you can reset parameters to their factory settings, for example.
SINAMICS DCM DC Converter
Operating Instructions, 1.2012, C98130-A7066-A1-05-7619
9.3 Controlling via the AOP30 operator panel
Operation
321