Starting The Drive Project - Siemens SINAMICS DCM Operating Instructions Manual

8.4.2.3

Starting the drive project

You have generated a project and saved it to your hard disk. The next step is to transfer your
project configuration data to the drive unit.
Transferring a STARTER project to the drive unit
The following steps are required to transfer the STARTER project created offline to the drive
unit:
Step
If the following screen appears after step 1, select the Download to target device menu
command and continue with step 3. Otherwise, continue with step 2.
Figure 8-29
SINAMICS DCM DC Converter
Operating Instructions, 1.2012, C98130-A7066-A1-05-7619
1 Select the menu command
Project > Connect to target system
Online/offline comparison
8.4 Commissioning with the STARTER commissioning tool
Commissioning
Selection in the
toolbar
259