Siemens SINAMICS DCM Operating Instructions Manual page 514

Maintenance
11.1 Upgrading software releases
Step 6: Load into the target system, RAM to ROM
Load the project into the drive (load into the target system) to upgrade the charts in the drive
to the new version and permanently save the parameter assignment (carry out RAM to
ROM).
512
– Shift the DCC library, which appears in the "Libraries installed in Starter", to the right
with ">>"
Figure 11-3 Importing the DCC library (2)
– Select "Accept"
– The chart is compiled into the new version
– Perform these steps for all DCC charts which are in the drive.
Operating Instructions, 1.2012, C98130-A7066-A1-05-7619
SINAMICS DCM DC Converter