Siemens SINAMICS DCM Operating Instructions Manual page 310

Operation
9.2 Parameterizing using the BOP20 (Basic Operator Panel 20)
Parameter display
The parameters are selected in the BOP20 using the number. The parameter display is
reached from the operating display by pressing the "P" key. Parameters can be searched for
using the arrow keys. The parameter value is displayed by pressing the "P" key again. You
can toggle between the drive objects by simultaneously pressing the keys "FN" and the
arrow keys. You can toggle between r0000 and the parameter that was last displayed by
pressing the "FN" key in the parameter display.
Figure 9-10
308
Parameter display
Operating Instructions, 1.2012, C98130-A7066-A1-05-7619
SINAMICS DCM DC Converter