Right-Side Components; Removing Right-Side Components - Tracker Off-Road 500S Service Manual

FI602
29. Install the spark plug and tighten securely; then
install the timing inspection plug.

Right-Side Components

NOTE: For efficiency, it is preferable to remove and

disassemble only those components which need to be
addressed and to service only those components. The
technician should use discretion and sound judgment.
AT THIS POINT
To service any one specific component, only limited dis-
assembly of components may be necessary. Note the
AT THIS POINT information in each sub-section.
NOTE: The engine/transmission does not need to be

removed from the frame for this procedure.
Removing Right-Side
Components
A. Water Pump
B. Speed Sensor
C. Magneto Cover/
Stator Assembly
1. Remove the coolant hose connecting the water pump
to the cylinder; then remove the water pump cover.
FI538
2. Remove the water pump housing assembly noting
the location of the longer cap screw. Account for a
gasket and two alignment pins.
60
FI539
FI541
3. Remove two cap screws and the oil bolt securing the
oil pressure relief line to the engine. Account for two
crush washers and an O-ring.
FI544
4. Remove the water pump drive gear; then remove the
speed sensor housing assembly. Account for two
alignment pins, a gasket, and two seal washers.
FI543