Accelerator Pedal - Tracker Off-Road 500S Service Manual

PK127
6. Install the hub assembly onto the splines of the shaft.
PK128
7. Using Hub Retaining Wrench, secure the hub assem-
bly with the nut. Tighten to 200 ft-lb (271.2 N-m).
PK129
8. Install a new cotter pin.
NOTE: If necessary, further tighten the hub nut

clockwise to allow the installation of a new cotter pin.
PK130
9. Secure the brake line to the knuckle; then secure the
brake caliper to the knuckle with the two new
"patch-lock" cap screws. Tighten to 20 ft-lb.
PK106
10. Install the wheels and using a crisscross pattern,
tighten the wheel nuts in 20 ft-lb (27.2 N-m) incre-
ments to a final torque of 45 ft-lb (61.2 N-m) (steel
wheel), 60 ft-lb (81.6 N-m) (aluminum wheel w/black
nuts), or 80 ft-lb (108.8 N-m) (aluminum wheel w/
chrome nuts).
11. Remove the vehicle from the support stand.

Accelerator Pedal

REMOVING
Release the return spring (A) from the accelerator pedal,
then remove the throttle cable from the pedal. Remove
the E-clip (B); then remove the pedal. Account for the
washers (C).
PK131A
INSTALLING
Place one washer into position. Install the pedal and then
the second washer. Secure with a new E-clip. Install the
throttle cable and return spring to the pedal.
CAUTION
Check for smooth accelerator cable operation. Verify
the pedal returns to the idle position.
25