Tracker Off-Road 500S Service Manual page 139

PK245A
2. Remove the four cap screws securing the rear caliper
mount to the gear case. Record the locations of the
two different-length cap screws, which require
patch-lock (A). Account for four crush washers.
PK246A
3. Remove the bracket from the gear case. Account for
the two dowel pins.
PK247
4. Place the gear case on its side; then remove the cap
screws securing the housing cover to the housing. If
necessary, use the pry point to aid in removal of the
cover. Account for the cover side shim.
PK248
5. Remove the ring gear from the housing. Account for
the housing side shim.
PK249
6. Remove the pinion shaft seal; then, using the Pinion
Gear Lock Collar Socket, remove the lock collar.
PK251
PK250
137