Tracker Off-Road 500S Service Manual page 136

PK237
6. Using the Boot Clamp Tool, install and secure the
large outside diameter clamp.
PK238
Removing Inboard CV Joint
1. Using the Boot Clamp Tool, remove both clamps
from the inboard CV joint. Slide the boot away from
the joint.
PK239A
2. Using a pick or small flat blade screw driver, remove
the circlip stop ring (A) from the CV housing.
Remove the housing.
134
PK240A
PK241
3. Note the orientation of the CV joint to the half-shaft.
Remove the snap ring securing the joint to the shaft.
Remove the CV joint; then remove the boot.
PK242A
Installing Inboard CV Joint
1. Place the small diameter clamp and new boot onto
the axle.
2. Install the CV joint onto the axle with the large
tapered side located toward the end of the axle. Posi-
tion a new snap ring so the sharp edged side faces
toward the end of the axle.
 NOTE: In the inboard boot, use the final 80 grams
(2/3 of contents) of grease from the pack in the bear-
ing housing.