Preparation For Storage - Tracker Off-Road 500S Service Manual

When using ethanol-blended gasoline, it is not necessary
to add a gasoline antifreeze since ethanol will prevent the
accumulation of moisture in the fuel system.
CAUTION
Do not use white gas. Only approved gasoline additives
should be used.
RECOMMENDED ENGINE/
TRANSMISSION OIL
CAUTION
Any oil used in place of the recommended oil could
cause serious engine damage. Do not use oils which
contain graphite or molybdenum additives. These oils
can adversely affect clutch operation. Also, not recom-
mended are racing, vegetable, non-detergent, and cas-
tor-based oils.
The recommended oil to use is ACX All Weather syn-
thetic engine oil, which has been specifically formulated
for use in this engine. Although ACX All Weather syn-
thetic engine oil is the only oil recommended for use in
this engine, use of any API-certified SM 0W-40 oil is
acceptable.
OILCHARTJ
RECOMMENDED FRONT
DIFFERENTIAL/REAR DRIVE
LUBRICANT
The recommended lubricant is SAE-approved 80W-90
hypoid. This lubricant meets all of the lubrication
requirements of the front differential and rear drive.
CAUTION
Any lubricant used in place of the recommended lubri-
cant could cause serious front differential/rear drive
damage.

Preparation for Storage

The manufacturer recommends the following procedure to
prepare the vehicle for storage. An authorized dealer should
perform this service; however, the owner/operator may per-
form this service if desired.
CAUTION
Prior to storing this vehicle, it must be properly ser-
viced to prevent rusting and component deterioration.
1. Clean the vehicle thoroughly by washing dirt, oil, grass,
and other foreign matter from the entire vehicle. Allow
the vehicle to dry thoroughly. DO NOT get water into
any part of the engine or air intake.
2. Either drain the gas tank or add a fuel stabilizer to the
gas in the gas tank.
3. Clean the interior of the air filter housing.
4. Plug the hole in the exhaust system with steel wool.
5. Apply light oil to the upper steering shaft via the access
hole. Remove the rubber plug located on the left side of
the steering column cover and plungers of the shock
absorbers.
PK094A
6. Tighten all nuts, bolts, cap screws, and screws. Make
sure rivets holding components together are tight.
Replace all loose rivets. Care must be taken that all cal-
ibrated nuts, cap screws, and bolts are tightened to
specifications.
7. Fill the cooling system to the bottom of the stand pipe
in the radiator neck with properly mixed coolant. Check
the coolant level in the reservoir tank; it should be in
between the MIN and MAX markings.
8. Disconnect the battery cables (negative cable first);
then remove the battery, clean the battery posts and
cables, and store in a clean, dry area.
NOTE: For storage, use a battery maintainer or make
sure the battery is fully charged (see Battery section in
this manual).
9. Store the vehicle indoors in a level position.
CAUTION
Avoid storing outside in direct sunlight and avoid using a
plastic cover as moisture will collect on the vehicle caus-
ing rusting.
5