Shift Lever; Shift Cable - Tracker Off-Road 500S Service Manual

Shift Lever

REMOVING
NOTE: The dash must be removed prior to replace-

ment of the shift lever (see Dashboard).
1. Remove the E-clip (A) and washer (B) connecting
the shift cable to the shift lever. Account for the
bushing (C).
PK132A
2. Remove the cap screw (A) and washer securing the
shift guide (B) to the shift lever shaft. Remove the
guide and shift lever (C). Account for the three
washers.
PK133A
INSTALLING
1. Place one larger outside diameter washer onto the
shift lever shaft then grease; then slide the shift lever
shaft into the frame.
2. Place a second larger outside diameter washer onto
the shift lever shaft; then install the shift guide onto
the shift lever shaft. Secure using a new patch lock
cap screw with the smaller outside diameter washer.
26
PK133
3. With the bushing (C) in place on the shift lever shaft,
install the shaft cable. Secure it with a washer (B)
and a new E-clip (A).
PK132A
4. Install the dashboard (see Dashboard).
5. Check for proper shifter operation (see Periodic
Maintenance/Tune-Up — Shift Cable).

Shift Cable

REMOVING
1. Remove the seat; then remove the plastic rivet secur-
ing the front left inner fender panel. Remove the
panel.
PK134A
2. From under the dash, remove the E-clip securing the
shift cable end to the shift lever guide. Account for
the washer and bushing.