Tracker Off-Road 500S Service Manual page 29

PK132
3. From under the front body panel, measure the
installed length of the threads; then loosen the cable
adjuster nuts. Slide the cable out of the bracket.
PK101
4. From under the seat, remove the E-clip (A) securing
the cable end to the shift arm stud. Account for the
washer (B) and bushing (C).
PK100A
5. Measure the installed set length of the threads; then
loosen the adjuster nuts. Remove the shift cable from
the bracket.
6. Remove the center floorboard panel and any cable
ties securing the shift cable to the chassis noting their
location; then remove the shift cable.
PK102
 NOTE: If the cable is being replaced, connect the
new cable to the end of the existing cable and pull the
new cable into place.
INSTALLING
1. Route the cable into position making sure there are
no kinks or sharp bends.
2. Guide the shift cable into the shift cable bracket.
Install the cable end to the shift arm stud and secure
with a new E-clip. Using the measured length (from
step 5), install the shift cable into the bracket; then
secure the adjuster nuts.
PK100
3. From under the front body panel, guide the shift
cable into the bracket; then using the measured
length (from step 3), secure the adjuster nuts to the
bracket. Install the cable end to the shift lever attach-
ment using a new E-clip. Tighten each nut to secure
the cable to the bracket.
4. Fasten the shift cable to the chassis with the previ-
ously identified cable tie locations.
5. Shift the transmission through all positions making
sure the each gear position illuminates the appropri-
ate gears selected and that Park Indicator illuminates
only when fully in Park. Adjust as necessary.
6. Install the center floorboard panel, front right access
panel, and seat.
27