Tracker Off-Road 500S Service Manual page 48

PK173A
19. Remove the cap screw securing the gear shift arm to
the shift shaft. Note the alignment punch marks (A)
and (B) for assembly purposes. Measure and record
the installed threaded set length (E) of the shift cable
housing in the shift cable bracket. Loosen the two
adjuster nuts; then secure the shift cable out of the
way. Disconnect the gear selector switch (C), speed
sensor (D), crank position sensor and ACG connec-
tors.
PK174A
PK102A
20. Remove the large and small diameter coolant outlet
hoses from the cylinder head coolant fitting.
46
PK175
21. Remove both large and small diameter coolant return
hoses from the water pump.
PK176
22. Match mark the flanges; then remove the cap screws
securing the front and rear drive shaft flanges to the
front and rear engine flanges. Once the cap screws
are removed, separate each flange from one another.
PK177
23. Remove the cap screws securing the front engine
cradle to the frame; then remove the lock-nuts secur-
ing the rear engine cradle to the frame. Discard the
lock nuts.