Dashboard - Tracker Off-Road 500S Service Manual

INSTALLING
1. Place the front of the floor into position in the vehi-
cle first; then lower the rear and push down into posi-
tion.
2. Secure the floor with the cap screws.
3. Install the accelerator and brake pedals using new E-
clips. Additionally, use a new cotter pin when secur-
ing the clevis pin of the master cylinder push rod.
4. Install the center foot guard; then install the dash-
board (see Dashboard).

Dashboard

REMOVING
1. Remove the seat, steering wheel, shift lever handle, and
steering column covers.
2. Remove the cap screws and plastic rivets securing
the engine compartment panel to the frame; then
remove the panel.
PK151A
3. Remove and disconnect the instrument gauge; then
remove the four Allen-head cap screws securing the
center dash panel. Remove the ignition switch from
the panel; then disconnect the 2WD/4WD switch,
override switch, and accessory plug.
PK152A
4. Remove the plastic rivets securing the rubber splash
guard from behind the accelerator and brake pedals;
then remove the guard.
PK153A
5. From under the dash, disconnect the light switch
connector; then remove the female side of the con-
nector from the frame.
PK154
6. Remove the cap screws (A) and plastic rivets (B) to
remove both left and right side panels.
PK093B
NOTE: To remove the right side panel assembly, the

gas tank cap and an additional plastic rivet, located
behind the right-rear ROPS tube securing the rear
splash panel to the side panel, must be removed.
33