Hydraulic Brake System - Tracker Off-Road 500S Service Manual

PK099
If either park or low range cannot be reached, the shift
cable must be adjusted.
ADJUSTING SHIFT CABLE
1. Place the transmission in park; then remove the seat.
2. Make sure the shift lever is in park; then remove the
E-clip (A) securing the cable end to the shift arm
stud. Account for the washer (B) and bushing (C).
PK100A
3. Loosen nuts (A) and (B) found under the front body
panel and adjust the cable housing to align the shift
cable end to the shift arm stud.
PK101A
4. If proper cable adjustment cannot be achieved after
performing step 3, utilize the second cable adjust-
ment found under the seat.
14
PK102
5. Place the bushing and cable end onto the shift arm
stud; then install the washer and a new E-clip.
Tighten the nuts (A) and (B) to 8 ft-lb (10.9 N-m).
6. Check each gear shift position for proper gear selection
and make sure the proper icon illuminates on the LCD.

Hydraulic Brake System

 NOTE: This ROV is equipped with hydraulic
brakes at the front wheels along with a shaft-mounted
rear hydraulic brake.
CHECKING/BLEEDING
The hydraulic brake system has been filled and bled at
the factory.
1. With the master cylinder in a level position, check
the fluid level in the reservoir. If the level in the res-
ervoir is not above the MIN, add DOT 4 brake fluid.
PK030A
2. Depress the brake pedal several times to check for a
firm brake. If the brake is not firm, the system must
be bled. To bleed the brake system, use the following
procedure:
A. Remove the cover and fill the reservoir with
DOT 4 brake fluid; then install and secure the
cover.
B. Slowly depress the brake pedal several times.