Tracker Off-Road 500S Service Manual page 76

9. Install the one-way clutch making sure that the green
dot or the word OUTSIDE is directed away from the
crankcase. There is also a directional arrow to indi-
cate the correct orientation of installation on the cen-
trifugal clutch.
NOTE: When viewing the centrifugal clutch as

shown below, the normal rotation of the clutch is
clockwise.
MD1286A
FI741
B. Clutch Cover
C. Fixed Drive Face
D. Movable Drive Face
NOTE: Steps 1-9 in the preceding sub-section must

precede this procedure.
1. Grease the inner and out lips of the seal; then using
an appropriately sized seal driver, drive a new seal
into the inner clutch cover housing.
2. On the opposite side of the clutch cover, verify the
seal is fully seated.
MD1115
74
3. Place a new bearing into position with the sealed side
of the bearing facing down; then using an appropri-
ately sized bearing driver, press the bearing via the
outer race into the inner clutch cover. Apply blue
Loctite #243 to the threads of the two Phillips head
screws and secure the two retainers.
! WARNING
Whenever a hydraulic press is used, a protective shield
must be in place on the press and it must be utilized.
Otherwise severe bodily damage can occur. Always use
protective eye wear and clothing when using a hydrau-
lic press.
FI737
FI734
4. Lubricate the inner race of the centrifugal clutch
housing bearing with engine oil; then using a bearing
driver and ball peen hammer, drive the clutch hous-
ing into the bearing until it fully seats.
FI738
5. With a new O-ring installed into the spacer, place the
spacer over the centrifugal clutch housing shaft and
fully seat it into the inner clutch cover seal.