Tracker Off-Road 500S Service Manual page 91

PK169
PK168
13. With the help of an assistant, place the rear ROPS
and seat frame assembly back onto the frame.
14. Loosely install the cap screws securing the center of
the seat frame to the main frame.
PK182
15. From each side of the vehicle, loosely install the
eight cap screws securing the outside of the seat
frame to the top of the main frame.
PK166A
16. Loosely install the cap screws from the front of the
seat frame to the main frame.
PK165A
17. Install new patch-lock cap screws and nuts securing
the front and rear ROPS assemblies together. Tighten
the ROPS fasteners to 47 ft-lb (63.9 N-m).
PK089
18. Tighten the cap screws from steps 14 and 16 to 22 ft-
lb (29.9 N-m).
19. Tighten the cap screws from step 15 (A) to 45 ft-lb
(61.2 N-m) and (B) to 22 ft-lb (29.9 N-m).
PK166B
20. Route the wiring harness along the front of the seat
frame. Secure the thermostat bracket to the bottom of
the seat frame. Install the rear gear case bladder to
the center splash panel. Install the CVT intake and
exhaust ducts. Connect and secure the driver's seat
belt limiter switch connector.
89