Setting Ip Parameters For The Total Access 850 - ADTRAN Total Access 850 System Manual

DLP-3 Setting IP Parameters for the Total Access 850
Introduction
The Total Access 850 comes pre-programmed for default Telnet access. The following IP
parameters apply:
•
•
•
•
For security purposes, change the default Telnet password during the initial unit
configuration. (Refer to System Config > Management > Telnet Access > User List on
page 77 for more details.)
If the Total Access 850 is connected to an IP network for Telnet, TFTP, or SNMP management, there are
several IP parameters which must be set for the unit to communicate with the network. These parameters
are described in this DLP along with the procedures for setting them.
Please see your Network Administrator for the proper assignment of the following
parameters:
Prerequisite Procedures
This procedure assumes that the Total Access 850 unit is connected to an IP network and is powered up.
Tools and Materials Required
• VT100 compatible terminal or computer with terminal emulation software
• Appropriate cable to connect terminal to the Total Access 850 (customer-provided)
• DB-9 male to DB-9 female adapter (customer-provided) for connecting to the RCU faceplate
port
• DB-9 female to RJ-45 female adapter (ADTRAN proprietary) for connecting to the
rear of the unit
To prevent electrical shock, do not install equipment in a wet location or during a
lightning storm.
Electronic modules can be damaged by static electrical discharge. Before handling
modules, put on an antistatic discharge wrist strap to prevent damage to electronic
components. Place modules in antistatic packing material when transporting or storing.
When working on modules, always place them on an approved antistatic mat that is
electrically grounded.
64203376L1-1B
IP Address: 10.0.0.1
Subnet Mask: 255.255.255.0
User: guest
Password: password
,
IP A S
DDRESS UBNET
© 2004 ADTRAN, Inc.
, and
M D G
ASK EFAULT ATEWAY
.
CRAFT
port on the
CRAFT
219