ADTRAN Total Access 850 System Manual page 200

Section 4 User Interface Guide
The following example provides step by step instructions for configuring the Total Access 850 T1 ATM
system ( and
I
NTERFACES
parameters should be set according to your system need. Refer to System Info on page 73 and System
Config on page 75 for more details.
1. Setting up the Interfaces
For more details on the configuration parameters discussed in this section, refer to the following pages:
Network T1 menus beginning on
FXS menus beginning on
Step
1 From the main menu, select I
Highlight the C
2
Right arrow to select F
3
This format must match the format used by the other units in the
network.
4 Set the L
This line code must match the line code used by the other units in the
network.
Set the E
5
usually sufficient.
Set the CSU L
6
whether looping to this unit from another unit will be allowed.
200
) for a standard voice application. System Info and System Config
L2 P
ROTOCOL
page 94
page 103
T1 Interface Setup Instructions
menu for the T1 interface and press <E
ONFIG
ORMAT
C to B8ZS or AMI.
INE ODE
or line build out. The default setting of 0
QUALIZATION
option to E
PBK
© 2004 ADTRAN, Inc.
Total Access 850 System Manual
Action
.
NTERFACES
and choose ESF or SF.
, D , or D
NABLE ISABLE ISABLE
>.
NTER
B is
D
A based on
LL
64203376L1-1B